Garage Door: Safety Cable Repair | 916-218-4931
Garage Door Repair - Garage Door Installation
916-218-4931

“Family Owned and Locally Operated”

Garage Door: Safety Cable Repair

Safety cables may be the single most protective feature of your garage door. They prevent broken springs from injuring loved ones and/or damaging valuable property. Though they are lighter, they resemble garage door cables. Safety cables attach to the wall in closest proximity to the stationary pulleys. Sometimes they are attached to the garage door track. The cables are then laced through springs, and attach to the support as the garage door spring.

Garage door safety cables are relatively simple to install. They can generally be purchased as a kit which contains all of the necessary hardware. In most instances, it only requires about an hour for installation. Inspect your garage door track in order to create a comprehensive list of required parts. This includes fasteners, s-hooks, and eyebolts etc. This way should the kit not contain everything you will need, you will have it on hand.

Kits, garage door components, required tools, and necessary safety wear may be purchased online or in a home improvement store. These items may also be available at a local garage door company as well. The garage door owner’s manual most likely contains an order form; however, this will probably be the most expensive route.

Reasons for Garage Door Safety Cables

Garage door springs are responsible for an immense amount of pressure. Should the spring snap without safety cables in place the result could be extensive damage to valuable property, severe bodily injury, or even death. The amount of pressure which would drive the spring across the garage creates enough force to penetrate a wallboard which is double layer and 5/8 inches thick. This amount of force can completely destroy a windshield which can cost $400 or more to replace.

As mentioned replacement and/or installation is quite simple. It requires lacing the cable through the garage door spring and being able to remain steady while on a ladder. Upon the installation of one side all moving components should inspected prior to installing the cable on the opposite side. Ensure that the garage door system in functioning properly. It is also important to make sure that the safety cable is not pulled too taught. A minute amount of slack is just perfect.

Safety Cable Installation

  • First thread the open end of the safety cable through the horizontal hole in the metal garage door frame. This should be in close proximity to the location at which pulley’s cable affixes. The hole closest to the opening of the garage door is best as this will reduce the possibility of binding.
  • Next thread the garage door safety cable upward through the middle of the spring.
  • Now, lace the garage door safety cable through the hole which is located in the upper portion of the metal spring support that is vertical. This should be the location at which the spring is attached. Loop the safety cable back and then use a cable clamp to secure it to itself.
  • The last step is to slowly test the function of the garage door to ensure it is not going to bind or inhibit the door.

Our team of garage door specialists will be happy to visit your home and install a brand new set of safety cables for your family. Just give one of our caring reps a call now. We can assist you with any and all of your garage door needs.

This entry was posted in Blog, Uncategorized and tagged , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *